54 Maneb or maneb preparations not meeting the definition of Division 4.3 or any other hazard class are not subject to the requirements of this subchapter when transported by motor vehicle, rail car, or aircraft. Nitrocellulose membrane filters covered by this entry, each with a mass not exceeding 0.5 g, are not subject to the requirements of this subchapter when contained individually in an article or a sealed packet. 13 The words Inhalation Hazard shall be entered on each shipping paper in association with the shipping description, shall be marked on each non-bulk package in association with the proper shipping name and identification number, and shall be marked on two opposing sides of each bulk package. We recommend you directly contact the agency responsible for the content in question. 134 This entry applies only to vehicles powered by wet batteries, sodium batteries, lithium metal batteries or lithium ion batteries, and equipment powered by wet batteries or sodium batteries that are transported with these batteries installed. For Federal Register citations affecting 172.102, see the List of CFR Sections Affected, which appears in the Finding Aids section of the printed volume and at www.govinfo.gov. 200 Division 1.4G consumer fireworks may be certified for transportation by a DOT-approved Fireworks Certification Agency in accordance with the provisions of 173.65 of this subchapter. Furthermore, lithium batteries installed in a cargo transport unit, designed only to provide power external to the transport unit must be described using the proper shipping name Lithium batteries installed in cargo transport unit found in the 172.101 Hazardous Materials Table. N91 The use of a non specification sift-proof, non-bulk, metal can with or without lid, or a non specification sift-proof, non-bulk fiber drum, with or without lid is authorized when transporting coal tar pitch compounds by motor vehicle or rail freight. 121 This substance, when containing less alcohol, water or phlegmatizer than specified, may not be transported unless approved by the Associate Administrator. With less than 10 percent formaldehyde, are not subject to this subchapter. B10 MC 300, MC 301, MC 302, MC 303, MC 305, and MC 306 and DOT 406 cargo tanks, and DOT 57 portable tanks are not authorized. The presence of a Class 8 hazard must be communicated as required by this part for subsidiary hazards. A10 When aluminum or aluminum alloy construction materials are used, they must be resistant to corrosion. (eg: Energy storage capacity means the energy held by a capacitor, as calculated using the nominal voltage and capacitance. Comparative fire testing between a package as prepared for transport (including the substance to be transported) and an identical package filled with water must show that the maximum temperature measured inside the packages during testing does not differ by more than 200 C (392 F). Symbols, if used, must be registered with the Associate Administrator. B30 MC 312, MC 330, MC 331 and DOT 412 cargo tanks and DOT 51 portable tanks must be made of stainless steel, except that steel other than stainless steel may be used in accordance with the provisions of 173.24b(b) of this subchapter. Oxygen cylinders with installed actuating cartridges as prepared for transportation must have an effective means of preventing inadvertent activation. Dry batteries not specifically covered by another entry in the 172.101 Table are covered by this entry (i.e., Batteries, dry, sealed, n.o.s.) 102 The ends of the detonating cord must be tied fast so that the explosive cannot escape. 332 Magnesium nitrate hexahydrate is not subject to the requirements of this subchapter. information or personal data. 137 Cotton, dry; flax, dry; sisal, dry; and tampico fiber, dry are not subject to the requirements of this subchapter when they are baled in accordance with ISO 8115, Cotton Bales - Dimensions and Density (IBR, see 171.7 of this subchapter) to a density of not less than 360 kg/m3 (22.1 lb/ft3) for cotton, 400 kg/m3 (24.97 lb/ft3) for flax, 620 kg/m3 (38.71 lb/ft3) for sisal and 360 kg/m3 (22.1 lb/ft3) for tampico fiber and transported in a freight container or closed transport vehicle. B78 Tank cars must have a test pressure of 4.14 Bar (60 psig) or greater and conform to Class 103, 104, 105, 109, 111, 112, 114 or 120. b. Lithium batteries conforming to paragraph a. of this special provision must be assigned to UN Nos. W100 Non-bulk flexible, fibreboard or wooden packagings must be sift-proof and water-resistant or must be fitted with a sift-proof and water-resistant liner. However, sediments remaining in the tank that meet the definition for a hazardous material are subject to the applicable regulations of this subchapter. It may not be used to describe articles, machinery, or apparatus for which a proper shipping name exists in the 172.101 Table. b. TABLE 2 lists . 46 This material must be packed in accordance with packing method OP6 (see 173.225 of this subchapter). These provisions apply only to transportation by rail. Each special provision is indicated using a numeric or alphanumeric code. Table I - Maximum Ambient Temperature - Gasoline. 61 A chemical oxygen generator is spent if its means of ignition and all or a part of its chemical contents have been expended. Individual Name: Mr. David Comen. The eCFR is displayed with paragraphs split and indented to follow (You can unsubscribe anytime), Learn More About USDOT/HazMat Transportation, generalpackaging requirements of173.24, Frequently Asked Questions Regarding the Regulations of the Resource Conservation and Recovery Act. A lighter refill exceeding 4 fluid ounces capacity (7.22 cubic inches) or containing more than 65 grams of fuel must be classed as a Division 2.1 material, described with the proper shipping name appropriate for the material, and packaged in the packaging specified in part 173 of this subchapter for the flammable gas contained therein. 21 This material must be stabilized by appropriate means (e.g., addition of chemical inhibitor, purging to remove oxygen) to prevent dangerous polymerization (see 173.21(f) of this subchapter). site when drafting amendatory language for Federal regulations: 172-123, 55 FR 52582, Dec. 21, 1990]. N73 Packagings consisting of outer wooden or fiberboard boxes with inner glass, metal or other strong containers; metal or fiber drums; kegs or barrels; or strong metal cans are authorized and need not conform to the requirements of part 178 of this subchapter. TP24 The portable tank may be fitted with a device to prevent the build up of excess pressure due to the slow decomposition of the hazardous material being transported. In addition, a lighter design intended to contain a non-pressurized Class 3 material is excepted from the examination and testing criteria specified in 173.308(b)(3). Be ASME Code (U) stamped for 100% radiography of all pressure-retaining welds; b. 52 This entry may only be used for substances that are too insensitive for acceptance into Class 1 (explosive) when tested in accordance with Test Series 2 in the UN Manual of Tests and Criteria, Part I (incorporated by reference; see 171.7 of this subchapter). A combination packaging consisting of a 4G fiberboard box with inner receptacles of glass or earthenware; b. b. b. Each reference in this column to a material which is a hazardous waste or a hazardous substance, and whose proper shipping name is preceded in Column 1 of the Table by the letter "A" or "W", is modified to include " 173.203" or " 173.213", as appropriate for liquids and solids, respectively, on those occasions when the . Tanks containing solidified methacrylic acid must not be reheated during transport. b. Gases of Division 2.3 and gases with a subsidiary risk of 5.1 must not be used as a propellant in a chemical under pressure. PDF 172.101 App A Appendix A to 172.101 - Pipeline and Hazardous Using the nominal capacitance (CN), rated voltage (UR) and the rated lower limit voltage (UL). US Department of Transportation (DOT) Pipeline Hazardous Materials Safety The maximum degree of filling must not exceed the degree of filling determined by the following: tr is the maximum mean bulk temperature during transport, tf is the temperature in degrees celsius of the liquid during filling, and. It must not freeze at temperatures above 15 C (5 F). What is Column 7 of the hazardous materials Table? Ch 6.0b Flashcards | Quizlet The pressure relief device must be preceded by a frangible disk in accordance with the requirements in 178.275(g)(3) of this subchapter to prevent crystallization of the product in the pressure relief device. In addition to the provisions applicable to the transport of Division 6.1 substances, the provisions of 173.421(c) and 173.443(a) of this subchapter apply. The receptacle must contain no hazardous materials other than the liquid nitrogen which must be fully absorbed in a porous material in the receptacle. A series of notes is used throughout TABLE 1 and TABLE 2 to provide additional information concerning certain hazardous substances. Hazardous materials not necessary for the safe and proper operation of the cargo transport unit must not be transported within the cargo transport unit. A 25 mm (1 inch) woven lining of asbestos or other approved material must be placed between the bolster slabbing and the bottom of the tank. This document is available in the following developer friendly formats: Information and documentation can be found in our Outage must be at least 5 percent at 98 C (208 F). b. The material may only be loaded with Class 3, Class 8, and Division 4.1 materials in Packing Group II or III. W9 When offered for transportation by water, the following Specification packagings are not authorized unless approved by the Associate Administrator: woven plastic bags, plastic film bags, textile bags, paper bags, IBCs and bulk packagings. Column 4 specifies the applicability of 178.275(g)(3) of this subchapter for the pressure relief devices. 350 Ammonium bromate, ammonium bromate aqueous solutions, and mixtures of a bromate with an ammonium salt are forbidden for transport. Nickel-metal hydride batteries subject to this special provision are subject only to the following requirements: (1) The batteries must be prepared and packaged for transport in a manner to prevent a dangerous evolution of heat, short circuits, and damage to terminals; and are subject to the incident reporting in accordance with 171.16 of this subchapter if a fire, violent rupture, explosion or dangerous evolution of heat (i.e., an amount of heat sufficient to be dangerous to packaging or personal safety to include charring of packaging, melting of packaging, scorching of packaging, or other evidence) occurs as a direct result of a nickel metal hydride battery; and (2) when loaded in a cargo transport unit in a total quantity of 100 kg gross mass or more, the shipping paper requirements of Subpart C of this part, the manifest requirements of 176.30 of this subchapter, and the vessel stowage requirements assigned to this entry in Column (10) of the 172.101 Hazardous Materials Table. The numbers and letters in the special provisions column are referred to in 49 CFR 172.102 with an explanation of their meanings.
Sam Fender Health Condition,
Highway 61 Accident Today,
Funny Things To Yell In A Crowd,
Friendly Farms Easter Menu,
Articles C
column 7 of the hazardous materials table